General Features:
ClassicTone Part Number 40-18106
CLASSICTONE #               TYPE                                                     REFERENCE #   
40-18106                   Output, 1W - 8 Ohm                             "Firefly"

Amps Used In: Very low wattage, push-pull style amps

Description: This is a small, push-pull style output transformer for use in very low wattage amplifiers using preamp style tubes such as 12AX7, 12AU7 and 12AT7 for approximately 1W or up to as much as 3.5W with tubes like 12BH7, etc. A great bedroom amp output transformer!

See Specifications for details!

Series: Plus
Note: These are reference numbers only.
See specifications for details.
Vintage Constructed Amplifier Transformers by Magnetic Components, Inc.
Part Number 40-18106
Project Style:  8 Ohm, 1W Push-Pull Output Transformer  
For Consumers, Small Builders & Small Resellers:

For Established Larger Amp Manufacturers & Larger Resellers:
(From us at ClassicTone at our great manufacturer's direct pricing. For direct orders of 12 pieces minimum & 18 pieces or more per item)
1 piece @ $35.57 each 
12 pieces @ $26.35 each

18 pieces @ $23.82 each

Would you like to order more than 18 pieces?
Please send us an email and supply us with this part number and the quantity that you would like to order. We will send you a new order form with the totals for that amount.
Order Here
Order Here
Order Here
*Disclaimer: Magnetic Components, Inc. is not affiliated with Fender Musical Instruments Corp., Marshall Amplification, Vox Amplification, Ltd., Leslie & Valco 
**All of the above listed amplifier models are trademarks of Fender Musical Instrument Corp., Marshall Amplification, Vox Amplification Ltd., Hammond Suzuki     USA, Ltd. (Leslie)  & Eastwood Guitars (Valco)
ClassicTone is a registered trademark of Magnetic Components, Inc. 
Copyright 2009-2020 Magnetic Components, Inc. All Rights Reserved.
WARNING: Transformers should always be installed by a professional electronics technician since there are high voltages involved and may result in serious physical harm to yourself, the transformer and/or your equipment if installed incorrectly. 
Paper layer wound like the vintage era originals!
Made in USA by us at Magnetic Components, Inc.
Made with premium materials
Features custom, solventless, varnish for vintage look and high performance
Proper raised mountings / No chassis modification required on most
Made with pre-tinned "Topcoat" PVC appliance wire for ease of soldering
RoHS Compliant
ClassicTone Series: Vintage, Plus & Custom
Power Transformers
Output Transformers
Other Related ClassicTone Offerings to Part Number 40-18106:
40-18111 (Project Style Upright, 120/240V To 380VCT@30mA, 6.3V@1.2A)

40-18106 (Project Style, 25K - 8 Ohm Push Pull)
Order Here
* Pricing May Vary